0
What else can I help you with?
What is the command to copy nvram to tftp?
To copy the contents of NVRAM to a TFTP server on a Cisco device, you can use the command: copy nvram tftp After executing this command, you will be prompted to enter the TFTP server's IP address and the filename for the backup. Make sure that the TFTP server is reachable and properly configured to accept the transfer.
Your computer say tftp no reply from server?
Either from below is possible:Link to TFTP server is temporarily damaged.Link to TFTP server is permanently damaged.TFTP is shut down.
What port number does the TFTP server use to accept request from client?
By default a TFTP server will accept connection requests on UDP port 69.
How do you configure a TFTP server on Fedora?
To configure a TFTP server on Fedora, first install the TFTP server package using the command sudo dnf install tftp-server. Next, edit the TFTP configuration file located at /etc/xinetd.d/tftp to enable the service by setting disable = no. Afterward, ensure the TFTP root directory (typically /var/lib/tftpboot) exists and has the appropriate permissions, then start and enable the xinetd service with sudo systemctl start xinetd and sudo systemctl enable xinetd. Finally, test the TFTP server using a TFTP client.
From what location can a router load the Cisco IOS during the boot process?
TFTP server, Flash
What does the command copy flash tftp accomplish?
it copies the ios FLASH to TFTP SERVER
How do you copy IOS software in cisco switches if tftp server not available?
You can use scp (depending on the IOS version), or you can use Xmodem over the console line.It's usually easier to setup a tftp server on a random PC or laptop, though.
What should be done before performing a backup an IOS image to a TFTP server?
Options are: A) Make sure the TFTP server is reachable across the network. B) Check the password authentication for TFTP access. C) Assure that the TFTP server has enough hard disk space for the IOS image. D) Make sure that the TFTP server can store text files. E) Adjust the maximum IP packet size to speed up transfer F) Verify that the TCP connection to TFTP server is ready. Anyone? Answer is all the above.
What is TFTP Server 9.1 used for?
"The TFTP server is used for webpages that have a maximum server load. It makes it easier for your webpage to get a lot of hits without going down, and keeps it secure."
What command and prompt are used to save a router configuration file to the TFTP server?
RouterC#copy running-config tftp [copy run tftp]
What command and prompt used to load a save configuration file from the TFTP server?
RouterC#cpoy tftp running-config [ cpoy tftp run ]
What is the purpose of a tftp server?
A TFTP (Trivial File Transfer Protocol) server is used to transfer files between different computer network within a network. This type of server is meant for use with a local area network (also known as a LAN). The purpose is of TFTP is to allow people to share information between computers in a closed system environment (such as an office or school).
