Simple description: The crank sensor sends information to the ECM so that it knows when to fire the plugs. It is located behind the harmonic balancer. It requires removing the balancer in order to remove and replace it.
Where is the crank sensor on a 95 chevy lumina car ?
That year model did not use are have a crank sensor.
My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.
Behind the harmonic balancer.
where is the crank sensor located on a 2005 chevy impala
There is not a camshaft sensor on the '93 3.1 Lumina, just a crank sensor on the back side of the engine between the block and the barrel of the transaxle. Easy enough to get to from underneath the car.
The crank sensor is located on the rear of the engine,on the right hand side about 5 inches from the oil pan.
what year? and what size engine? crank sensors are in different locations based on year and engine size.
I have a 92 lumina with a 3.1 and I found the crank sensor to be located on the passenger side of the engine in the back of the engine NOT on the side of the engine below the knock sensor. Hello, in my experience, all O2 sensors are located in the exhaust just after the manifold. It appears easy enough to change. If it is the crank position sensor you are looking for, take a look around the main pulley at the bottom of the engine, you may see a square-ish component located close to the actual pulley wheel, this would be the crank position sensor, it should have wires connected to it.
It is located on the crankshaft.
RH SIDE OF ENGINE AT END OF CRANKSHAFT
2010 chevy malibu intake position sensor