0
A digital penis enlarger
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you reduce glitches in digital circuit?
add a capacitor
Is there more than one way to charge a digital capacitor?
Nope
Can you replace a 470uf 10v capacitor with a 470 25v 105c high temp radial leads capacitor for a digital tv converter box?
Yes, as long as there is room to mount the larger capacitor. A better replacement might be a 470uF 16v capacitor, which should be smaller than the 25v cap. If necessary, insulating tubing can be put on the leads & the cap can be mounted off the board, or at an angle to the board. Remember to observe polarity when connecting the capacitor leads to the board. Note the orientation & markings on the old capacitor before unsoldering it.
What has the author DL Goodman written?
D.L Goodman has written: '16-bit digital filter interface using switched capacitor filters'
Can a capacitor be hooked to a DC circuit?
Yes, capacitors can be, and often are, used in DC circuits. At steady state DC conditions, the capacitor has near infinite impedance. Its value is in its ability to resist changes in voltage, so it can serve as a transient filter. There is almost always a small ceramic capacitor connected between VCC and ground next to IC's in a digital circuit, for that exact purpose.
How do timers work?
A resistor is connected between a voltage source and a capacitor, charging the capacitor slowly over a time. The actual time depends on the resistance value of the resistor and the capacitance value of the capacitor. Together they produce something that is described as their "time constant value". The 555 measures the capacitor voltage as it increases and compares it to a threshold to trigger things at certain time intervals, and also 555 has a circuit to discharge the capacitor and restart the charging process. By using clever circuit connections, a 555 with a resistor and capacitor can be used to generate pulses, delays, and periodic signals like pulse trains and low-speed clocks for digital circuits.
How do 555 timers work?
A resistor is connected between a voltage source and a capacitor, charging the capacitor slowly over a time. The actual time depends on the resistance value of the resistor and the capacitance value of the capacitor. Together they produce something that is described as their "time constant value". The 555 measures the capacitor voltage as it increases and compares it to a threshold to trigger things at certain time intervals, and also 555 has a circuit to discharge the capacitor and restart the charging process. By using clever circuit connections, a 555 with a resistor and capacitor can be used to generate pulses, delays, and periodic signals like pulse trains and low-speed clocks for digital circuits.
What is dc link capacitor?
when the DC current flows through the capacitor .the leakage of the charges is in capacitor called Dc leakage capacitor .
What two facctors determine the capacitive reactance of a capacitor?
The reactance of a capacitor is a function of -- the capacitance of the capacitor -- the frequency of the voltage across the capacitor
Can you by-pass a capacitor in an electric motor?
You can not by-pass the capacitor in an electric motor. Most are capacitor-start motors which require the capacitor to be operational in order to start. If the capacitor is not working then it will need to be replaced.
Why gang capacitor called so?
GANG capacitor is called so because it group of capacitor
How do I test a capacitor with a multimeter?
This is nearly impossible unless the digital multimeter has either:a built in capacitance meter functionan analog bargraphIt was actually much easier to do on the old style cheap analog multimeters with a needle using the ohms scale than it is on modern digital multimeters.
