0
What else can I help you with?
What special tool is required to remove the lower coolant line on a 1998 Cherokee Sport radiator?
Flatblade screwdriver. Would likely be easier if you moved the power steering pump, but its possible without doing that too.
How do you start a 1979 Chevy pickup with a broken ignition?
remove the ignition tumbler from column and crank it with a insulated handle flatblade screwdriver if the ignition is located in the dash remove key tumbler by inserting a small pin in the hole located above the key hole and it will pop out using a screwdriver and turn it over that way
Where does screwdriver used?
The screwdriver is used to tighten and loosen screws.
What is a crosshead screwdriver used for?
For a crosshead screw the "Phillips" screwdriver is used .
What is the proper use of flathead screwdriver?
A slotted screwdriver is properly used as... a screwdriver.
What are screwdriver used for?
A screwdriver is used to turn screws in or out.
What is stubby screwdriver?
A stubby screwdriver is a screwdriver that is much smaller than the average screwdriver. It is used to get into places not easy to access with a regular screwdriver.
Descride what to do if you jus spilled soda pop on your keyboard?
Place your keyboard upside down immediately. Then unplug it from the computer. still upside down, remove the affected keys by pushing a flatblade screwdriver under them and pushing up softly, get rid of the liquid in the keys and let the board dry
What is stubby?
A stubby screwdriver is a screwdriver that is much smaller than the average screwdriver. It is used to get into places not easy to access with a regular screwdriver.
What are the different types of screwdriver bits that can be used with a double-ended screwdriver?
The different types of screwdriver bits that can be used with a double-ended screwdriver include Phillips, flathead, Torx, and hexagonal bits.
How do you replace interior panel bulb on VW Polo S Reg?
what do you mean by panel? if its the one in between the sun visors, pop off the cover with a flatblade screwdriver (careful not to break the plastic supports), pull out the old bulb which should be long and thin and replace it. After that then pop the cover back on and hey presto.
What type of screwdriver is used when the screw head has one slot?
a flathead screwdriver
