A slotted screwdriver is properly used as... a screwdriver.
Use a flathead screwdriver, insert the end in the side of the head unit.
a flathead screwdriver
Pry it off with a flathead screwdriver.
I use a flathead screwdriver... but they make a tool. I would guess you could rent the tool from a sears or a Lowes.. but hey, if you have a lawnmower, i bet you have a screwdriver.
Whatever you do, make sure you keep it away from both phillips or flathead screws.
Remove all screws and use a flathead screwdriver to pop it out of the plastic sockets. Be careful, they break easily.
Standard (also known as flathead) & Philips. You use the type (there are many more) that match the slots in the screws that you are using.
There is one on the end panel of the dashboard. (i.e. the bit that you cannot see when the door is shut) just use a flathead screwdriver to open the cover.
With a hammer and a flathead screwdriver. I wonder how to open one of those 1999 lightsabers though.
Use a serrated blade to cut slit in the middle of the cap all the way thru until you hit the actual glass bottle. Use a flathead screwdriver and wedge in and then up towards the top. Pull up on the screwdriver to break plastic. Repeat if necessary.
There are two clips on the headlights. they are at a 90 degree angle. use a flathead screwdriver and slightly pry upward at the notch. they pop up and the headlight comes out.
i think it you just unclip it on the car not the van the clips are hard to see but they ar on the bottom of the trim my have to use a flathead screwdriver to pry them up and out.