answersLogoWhite

0

Use a flathead screwdriver, insert the end in the side of the head unit.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Why wont your factory monsoon head unit work after you took out your after market head unit it is a 2003 grand am?

Take it to a dealer and have them reset the security.


What is the unit of head pressure?

Unit of head pressure is psi.


How do you put a head unit into a 1994 ford explorer?

with a head Unit DRIVERRR


What is pump head unit?

Pump head unit; is either in Feets fluid- us unit or in meters fluid- metric units


What is the most powerful head unit?

Dual XDVDN8290 Multimedia Head Unit is one of the most powerful available.


How do you change head unit on Isuzu Axiom?

There are no known affter market head unit for te Axiom due to the AC controls being incorporated. Most users move the CD Deck to the rear cargo area, then the head unit goes in the arm-rest where the CD used to be, this'll only control the AC system. The after market head-unit can then be placed in the dash. You can also do away with the factory CD unit and go with a after-market unit to match uour new head-unit.


Why do your car head unit overheat when you play your subwoofers?

Your head unit probably doesn't have sufficient amperage to power the subwoofers.


How do i remove the head unit of a 2007 Mazda 6?

To remove the head unit of a 2007 Mazda 6, first disconnect the negative battery terminal to ensure safety. Then, use a flathead screwdriver to pry off the trim surrounding the head unit carefully. Remove the screws securing the head unit, typically located on the sides or top, and gently pull the unit out. Finally, disconnect the wiring harness and antenna cable from the back of the head unit to complete the removal.


Are there any car cd changers built into the head unit?

Yes, but in some cases you would have to install an aftermarket head unit.


How do you remove jaguar s type head unit?

To remove the head unit from a Jaguar S-Type, start by disconnecting the car battery to ensure safety. Use a flathead screwdriver to carefully pry off the trim surrounding the head unit, then remove any screws securing the unit in place. Gently pull the head unit out and disconnect the wiring harnesses at the back. Once disconnected, you can replace or repair the unit as needed.


How do you install a kenwood head unit?

Connect the positive (usually red), earth (usually black) and accessories (usually blue)into the new head unit making sure the positive is fused. Connect the speakers into the head unit and away you go.


How many watts does the factory stereo head unit produce in a 2004 jeep wrangler?

Not enough - cranking it up for extended periods shouldn't damage it, but the distortion from the head unit will probably roast the factory speakers quite nicely. Don't mess with it unless it's to take it out and go aftermarket.