There are no known affter market head unit for te Axiom due to the AC controls being incorporated. Most users move the CD Deck to the rear cargo area, then the head unit goes in the arm-rest where the CD used to be, this'll only control the AC system. The after market head-unit can then be placed in the dash.
You can also do away with the factory CD unit and go with a after-market unit to match uour new head-unit.
The code P01340 for a 2002 Isuzu Axiom indicates a problem with the oxygen sensor circuit, specifically related to the oxygen sensor in bank 1. This could be caused by a faulty sensor, wiring issues, or a problem with the engine control unit (ECU). Addressing this code typically involves inspecting the sensor and its connections for damage or corrosion. If the sensor is functioning properly, further diagnosis of the wiring and ECU may be necessary.
By sound system do you mean head unit? if so just about all head units will fit.
no, as long as the wattage of the speakers are compatible withe the head unit.e.g speakers 200 watts head unit below 200 ,or else you may blow speakers.
By sound system do you mean head unit? if so just about all head units will fit.
go to a shop
Check this Isuzu site: http://www.myisuzuparts.com/
it is not practical to change the head unit on a RX8 The above answer is correct. There are many ways to make an after market head unit "fit" into the RX8, but you will probably lose the steering wheel stereo controls. You can connect aftermarket amplifiers to the stock head units speaker output and use aftermarket speakers. Get the MP3/CDROM addition for the stock CDROM head unit from a Mazda dealer.
The oil sending unit in a 1992 Isuzu Trooper is located within the car's engine. The oil sending unit is responsible for determining the oil pressure.
You have to change the head unit to the ones which has an aux input or iPod connector because the OEM head unit only has a single CD/cassette player & radio.
Remove two 10mm bolts supporting the pedal. Disconnect the electronic unit connected to the pedal using a small flat head screwdriver. Take off two phillps screws attached to the unit.
Unit of head pressure is psi.
sending unit in tank