answersLogoWhite

0

Remove two 10mm bolts supporting the pedal. Disconnect the electronic unit connected to the pedal using a small flat head screwdriver. Take off two phillps screws attached to the unit.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the overdrive sensor on 1998 Isuzu NPR?

The sensor will be by the accelerator pedal


Is there a diagram of oxygen sensor location on an Isuzu trooper?

Yes, there is a diagram of the oxygen sensor location of a Isuzu Trooper. This diagram can be found in the cars maintenance manual.


94 Isuzu Trooper acceleration is sticking and almost caused a wreck what can cause this?

accelerator cable


Where is the oxygen sensor on a 2001 Isuzu Trooper?

on the exhaust manifold.


How do you replace the voltage regulator on a 1996 Isuzu trooper?

Its in the alternator


How do you manually reset the abs system in an Isuzu trooper?

replace the pump replace the pump


How do you replace fuel injectors on 99 trooper?

99 isuzu trooper smell gasoline in the engine compartment


What is the Location of 02 sensor for 1985 Isuzu trooper?

The oxigen sensor can be found on the exhaust manifold or exhaust pipe


Where is bank 2 sensor 2on Isuzu trooper?

Drivers side behind the convertor.


Where is bank 1 sensor 2 on a 2000 Isuzu trooper located?

Driver side


What engine can i replace my 1991 Isuzu bighorn with?

a trooper engine or a rodao engine


How do you replace a throttle sensor on a 2002 Isuzu trooper?

To replace the throttle position sensor (TPS) on a 2002 Isuzu Trooper, first disconnect the negative battery terminal to ensure safety. Locate the TPS on the throttle body, detach the electrical connector, and remove the screws securing the sensor. Install the new sensor in place, secure it with screws, reconnect the electrical connector, and finally, reconnect the battery terminal. After installation, it’s advisable to check for any error codes and perform a throttle position reset if necessary.