To replace the throttle position sensor (TPS) on a 2002 Isuzu Trooper, first disconnect the negative battery terminal to ensure safety. Locate the TPS on the throttle body, detach the electrical connector, and remove the screws securing the sensor. Install the new sensor in place, secure it with screws, reconnect the electrical connector, and finally, reconnect the battery terminal. After installation, it’s advisable to check for any error codes and perform a throttle position reset if necessary.
In a 1988 Isuzu Trooper, the throttle position sensor (TPS) is typically located on the throttle body, which is mounted on the intake manifold. It is situated near the butterfly valve of the throttle body, allowing it to monitor the position of the throttle plate as it opens and closes. To access it, you usually need to remove any engine covers or components obstructing the throttle body.
Yes, there is a diagram of the oxygen sensor location of a Isuzu Trooper. This diagram can be found in the cars maintenance manual.
on the exhaust manifold.
It is a Throttle Position Sensor
Its in the alternator
replace the pump replace the pump
99 isuzu trooper smell gasoline in the engine compartment
The oxigen sensor can be found on the exhaust manifold or exhaust pipe
Drivers side behind the convertor.
Driver side
a trooper engine or a rodao engine
Depends if you can neuter the trooper computer router hooter from a cuter commuter, Super!