One meaning of "key lock switch" is a switch that requires a physical key to turn. Many computers come with such switches installed. They cannot be turned on or turned off except by persons who have the key.
Another meaning is switch that can enable or block traffic from a keyboard. When the switch is thrown, the keyboard becomes inert. In some cases it can be set up like a screen-lock, where a password must be inserted or a physical key inserted in order to enable the keyboard.
no
Santa Fe is older
i have a 06 Chevy cobalt and can't get the key out of the ignition switch
for key switch replacementare you changing the key switch or the electric switch that attaches to the key switch key switch- take off columb cover remove ing electric switch then with 1/4 inch drill bit drill out top of studs then remove assembly and replace screw studs with new screws and switch cost, when i did mine was $160.00 good luck with project.
The ignition switch. Where the key goes in is the key tumbler.
to take the key switch out you need to press the little pin sized rod located on the bottom of the switch. once pushed in twist the switch out.
The key is inside of the key fob. There is a small switch on the back of fob. Push it towards the outside and hold it. While holding the switch, pull on the key ring and your key will slide out.
no
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.
how do install key ignition switch 1988 Chevy s10
You do not need a key to replace the ignition switch.