Sounds like a switch that would only provide power if a condition is met, i.e a lamp timer. I'm not positive though.
a control switch is a sort of remote controlled relay attached to home appliances which consumes more power.
Application: 1.For amplification of sound. 2.logic switch 3 oscillation 4 power amplification.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
control panel >> power options
pry out the control switch and disconnect the electrical connectors.install is reverse.
eBay
Could be a few different things- the transmission control module power or ground system, transmission range switch, wire harness problem or tcm logic problem. If it is the module it is somewere around 400 to replace. Good luck
To operate a relay ( I am calling "third relay") from two separate parallel control relays is called logic "or". Connect the power wire coming in to both of the paralleled relays' switch common contact. ( These relays are up to you to wire their coils and activate.) Depending on the logic required you will wire the third relay coil to the paralleled control relays normally open or normally closed contacts. That is: Do you you want the third relay to go on with the control relays activation or off?
The switch is designed to make or break the circuit. This gives the operator control over whether the power flows or not.
No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.
check switch on driver control panel
Your power window lock control on the driver's door has been switched on It is the rocker switch that goes left and right