answersLogoWhite

0

What is a map sensor on a 1990 cutlas and were is it?

Updated: 8/16/2019
User Avatar

Wiki User

17y ago

Best Answer

if it has a 3.3 there is no map sensor

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is a map sensor on a 1990 cutlas and were is it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1990 Dynasty have a MAP Sensor?

Yes.


Where is the MAP sensor on a 1990 Mazda B2200?

The map sensor is on the air intake line to the throttle body....


Where is the map sensor locatedon a 1990 ford 5.8 efi bronco?

The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.


What does code 33 mean on a 1990 lumina?

MAP sensor


Where is the PCV valve located on a 1990 PONTIAC Grand Prix?

The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.


Where is the location of the MAP sensor on a 1990 Buick LeSabre?

After consulting several sources, someone finally called a local Buick dealer who informed me that a 1990 LeSabre does NOT have a map sensor, it was the Mass Air Flow sensor that needs replacing.


Where is the map sensor on a 1990 Ford Ranger?

On the firewall on the pass side.


Where is the map sensor on a 1990 civic si?

The map sensor is located on the fire wall towards the passenger side right under the wind shield.


Do any one have a pic of a map sensor for a 1990 jeep Cherokee?

Below


Where is the map sensor on 1990 dodge shadow 4 cylinder?

passenger side


How do you replace and locate the map sensor in a 1990 Honda civic?

the map sensor is located on top the intake manifold and reads off map sensor just disconnect wire then get a Philips screw driver and take off then replace and put back on


Where would you locate the crank sensor on an 1988 Oldsmobile Cutlas Ciera?

On my 1990 the crank sensor is behind the vibration dampner. I just replaced it last week.Cost $35.00 at Auto Zone. Just be careful because you have to align the veins on the back of the dampner to go in between the grooves of the sensor.