Best Answer:Sash Clamp is used to clamp together when it is glued.
A bar clamp is used for making clamps
use for clamp the iron stand gently
these are 2 types of pinch clamps (where you pinch the clamp and when you let go it clamps
It is a multimeter with a clamp on facility to measure current using it as a current transformer.
pg clamp is known for parallel groove clamp,especially used in transmission line to hold transmission conductors in parallel.
If the two wires are on a parallel feed you would read the current through the parallel feeders. If the two wires are "hot " to the load and return back from the load the meter will read zero. The two magnetic fields that surround the wires when a current flows through them will cancel each other. As a result of this there will be no magnetic induction induced into the sensing coil of the clamp on meter.
If the two wires are on a parallel feed you would read the current through the parallel feeders. If the two wires are "hot " to the load and return back from the load the meter will read zero. The two magnetic fields that surround the wires when a current flows through them will cancel each other. As a result of this there will be no magnetic induction induced into the sensing coil of the clamp on meter.
Best Answer:Sash Clamp is used to clamp together when it is glued.
Out away that clamp Chair
to clamp the buret
Sliding clamp
The full form of TC clamp is TRI-CLOVER CLAMP.
bench voice, voice grip, g clamp, c clamp, hand clamp, jumper cable. these are only hand tools
A pinch clamp.
to clamp the screw
Steve Clamp was born in 1977.