0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is peak to peak?
Peak to Peak is the most positive peak to the negative peak value. Or find any peak value and multiply by 2.
What is the effective value of 200 volts peak-to-peak?
200 volts peak-to-peak is 100 volts peak, which is 70.7 volts rms (standing for root-mean-square) also called "effective". This 70.7 volts is the DC voltage with the same heating power as the peak-to-peak. The relationship is: rms (aka RMS) equals peak-to-peak divided by 2, then divided again by square-root of 2 (1.414). The division by 2 gets us from peak-to-peak to just peak. The next division takes us to rms. If you get an AC voltrage with no description, for exmple 120 volts AC, it is RMS (effective). The USA AC standard supply voltage is 120 (also called 117) volts RMS. The USA peak is 117 x 1.414 (square root of 2) = 165 volts peak, = 330 volts peak-to-peak.
Are peak-to-peak and rms voltage measurements the same?
No, the peak-to-peak voltage is 2sqrt(2) times as much as the rms for a pure sine-wave.
How to calculate the peak-to-peak value of a signal?
A: AC or our line voltage is sinusoidal in nature it goes up to a positive peak returns to zero and proceed to the negative peak. 120V AC is actually swinging from peak to peak. It is 120 volts but the peak is the 120 v times 1.41 or 169.2 volts and since it also go negative then the peak to peak 120 volts times 2.82 or 338.40 volts or twice the peak voltage
What is the peak to peak voltage for the AC line voltage in normal outlets of your house?
Peak - neutral for 120 volts RMS is 169 volts, or 120 * sqrt(2) Peak to peak will be 2 x this value, or 339 volts.
Where is the oil filter located on Mazda mx3?
Just jack the car up, and take a peak underneith, should notice it right off.
Consider the signal s(t) shown in figure 1:[1] Determine the impulse response of a filter matched to this signal and sketch it as a function of time.[2] Plot the matched filter output as a function of time.[3] what is the peak value of the output?
5rytrydsfsdfgdee56565754324ertdsghszafcxz`fdg
How do you reduce a ripple voltage?
You reduce ripple voltage by adding a low-pass filter. In the simplest case, you put a capacitor after the rectifier. The peak voltage will be the rectifier output voltage less the forward bias of the rectifier, while the minimum voltage will depend on current and capacitance. In a more complex case, you could use an LC filter, making the peak voltage smaller. Specifics are dependent on the power and performance requirements.
When was Peak to Peak Charter School created?
Peak to Peak Charter School was created in 1999.
What are peak marcellos traits?
PEAK CARCELLO is a really good person peak is helpful peak is genrous peak is really nice and kind peak is really smart peak is really smart around little sisters
What is peak to peak?
Peak to Peak is the most positive peak to the negative peak value. Or find any peak value and multiply by 2.
Why is the peak inverse voltage in a full wave rectifier 2VMAX?
Assuming that the rectifier will be followed by a filter capacitor, the p.i.v. should be at least twice the peak of the applied a.c. (The capacitor will charge to the peak of the applied a.c. On the next half cycle of the input, the peak of that cycle will be of the opposite sign to that of the stored voltage on the capacitor, so the two add - giving twice the peak.)
What is the amplitude for the function y equals 6sinx?
The amplitude of the function [ sin(x) ] is 1 peak and 2 peak-to-peak . The amplitude of 6 times that function is 6 peak and 12 peak-to-peak.
Is the peak a building in Hong Kong?
No, Victoria Peak (also known as Mount Austin or locally as "The Peak") is a natural landform. However, there are buildings on and around Victoria Peak, such as the Peak Galleria and the Peak Tram station.
Is Cathode ray oscilloscopes measure peak to peak value or average or root mean square value?
peak - peak.
If vm is maximum peak voltage of rectifier outputthis rectifier output is connected to the capacitor filterwhat will be the approximate dc output voltage to the capacitor filter?
It should be the rms value of your supply.
What is the highest in the Rocky Mountains?
colorado's peak colorado's peak colorado's peak
