Fold a piece of fabric in half. On the fold, make a mark about 4 inches down, or however far you want your dart to be. Begin sewing from the top, about 1 inch away from the fold, and sew straight toward your mark (you will be sewing diagonally). Don't back-stitch at the tip of the dart, or the fabric may not lay properly. Usually, if you are following a pattern, this process is explained in the instructions.
Darts are commonly used in blouses, skirts, and jackets.
a seam added to create structure to a garment
For a score to count, the tip of the dart must be touching the dart board.
Dart points are made of steel, they help the dart stick in the board.
Dart Drug ended in 1990.
Pretty fast The average speed when the dart hits the board is around 40mph. Most successful dart players do not throw the dart hard. Best technique is to incorporate some arc which is decreased when dart is thrown hard plus you lose control if thrown fast.
It all depended on what engine was in the dart, there were 2 differen't trannies.
1. Slash and Close 2. Pivot
a tracing wheel
For a score to count, the tip of the dart must be touching the dart board.
Darts give shaping, typically when sewing a skirt/pants they are located on the back of the skirt near the top. In a shirt/dress darts can be between the waist and the bust length wise or on the outside of the bust (between the bust and side)
The new dart?, not yet, the old dart?, yes.
Dart points are made of steel, they help the dart stick in the board.
The dart missed.We have won the dart match.In just a few seconds, the bullet would dart past his face.
Robert Dart
Nat Dart's birth name is Nathaniel Neil Dart.
Richard Dart's birth name is Richard Peter Dart.
Yes, the Recon CS-6 is not only compatible with the 18-Dart Clip but the 6-Dart Clip, the 18-Dart Drum and the 35-Dart Drum.
there is an "A" in dart and not in drt! :)