Home Theater
Ford Explorer Eddie Bauer
Ford Explorer XLT

What is a system control cable for a kenwood KR-795?


Top Answer
User Avatar
Wiki User
2007-08-25 21:57:40
2007-08-25 21:57:40

A system control cable is a cable attached between the Kenwood main receiver and a Kenwood component (ie. CD player, tape deck) to provide automatic operation of the component when the associated button is pressed on the receiver or its remote.

User Avatar

Related Questions

The Kenwood KDCHD942U in-dash deck comes with the ability to connect your Apple iPod.

It is probably the cruise control actuator cable. The actuator is what, through the commands of the cruise control system and driver imputs, determin a speed setting

The cable? The cable has no file system, its just a cable.

, The cable box communicates back to the computer system at the cable company, and that's about all it does. It'll send back info like a PPV movie you ordered with your remote control, subscription to special events, etc. It's what you would call a closed system.

Remove the radio/heater control module. Disconnect the temperature control cable at the base of the control assembly . It is on the center mound just to the right of the gas pedal. Take the heater control cable off of the back of the heater control module. Pull the temperature control cable off.

It attaches to throttle plate (next to throttle cable) to cruise control unit.

Most newer Kenwoods are compatible with iPods. For the one's that aren't you can hook into them directly with a mini-to-mini cable.

If the speakers are not powered (they don't plug into the wall), you can cut off the RCA plug, strip back the wires to a negative and positive lead, and connect them to the speaker posts of the receiver.

It is the system that actuates the throttle plate electronically. This van does not use a throttle cable.

You can reduce induced voltage in control cable by applying the following methods. 1. While laying control cable keep a minimum distance 300mm from the power cable. 2. If possible try to lay control cable on the separate cable tray. 3. Earth the Armour/ screen of the control cable on both side of the cable or at-least at one side. Some times it is not important to reduce the the induced voltage in control cable, but it's effect on relay or contactor as the contactor or relay does not pick-down even after the removal of the control supply. In that case it is recommended to use two relay/contactor in parallel and use the contacts in series or parallel for control circuit interlocking.

It doesn't have a speedometer cable. The system is all electronic..It doesn't have a speedometer cable. The system is all electronic..

a dog that has a remote control cable connected to it

remote control codes for samsung blue-ray on time warner cable remote control

Console cable of pbx system, it is a cable that will display the digital signal into monitor or screen or It is data cable that shows user interface for system configuration.

It depends on the internet system whether it is wireless system or wire system. If it is a wire system then you have to plug the internet cable into the computer.

Connect AUDIO OUT on the cable box to AUDIO IN on the surround system.

Micc (fire rated cable can use for fire alram system.

The answer depends on your cable system and area. You should contact your cable provider for assistance.

You can always use a store-bought remote control, but you may lose some features of the cable remote.

A straight cable will be sharper, have less play in the system.

Simplest way is to connect with a cross cable

No cable, all controls are done with electric motors.

Parents can use the Parental control device to block a channel on their cable television therefore control what their kids are watching whenever they are alone by themselves. This device is control by a PIN number that parents can set on their TV and or cable set up box.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.