A spring loaded pully that keeps the serpentine belt tight
under the hood
5 1/4"
In the right kick panel. On my 98 Intrigue it's it the engine compartment in the black box connected to the air filter.
it has 4 sensors two before cat and two after
you might need a thermastat. my 98 was doing the same thing. its easy and cheap to replace.
There is none, GM vehicles are not equipped with an inertia switch.
It is on the evaporator case and is held in with 2 screws.
Well i heard plenty of reasons but the one that actually worked for my olds intrigue 98' was replacing the blower motor resistor which cost about 20 bucks or so.....hope this helps
Need to ask a complete question please. Yes, 98 olds should come with a driver's window.
ITS IN THE FUSE BOX. THERES TWO OF THEM, ONE IS LABELED TOP BLOWER AND THE OTHER LOWER BLOWER.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.