0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How inefficiencies of compressor and turbine affect back work ratio and efficiency of gas turbine?
Inefficiencies in the compressor of a gas turbine cycle increase the back-work ratio and decrease the thermal efficiency of the gas turbine cycle, since they increase the compressor work.
Mechanical control system for an compressor?
Mechanical control system for an compressor?
Which type of compressor uses belts to turn the compressor?
Open drive.
What do thermal insulators have?
Thermal insulators have insulating capabilities. This means that they do not have any aspect that allows them to conduct thermal energy.
What is compressor turndown?
Turndown: The allowable operating range for the centrifugal compressor between the design point and the surge line at any given speed for a fixed compressor head.
Is it safe to use the unit even if your compressor is over heat?
Compressors have a thermal overload built inside that will shut down the compressor if the conditions are critical.
Is there a thermal limit switch for 2006 econoline van air conditioner?
Usually mounted on the compressor.
What is in a refrigerator that makes cold?
A fridge works by absorbing the thermal energy (heat) out of the things you put in it and a compressor pushes the thermal energy from the food through a tube into the air outside of it.
How inefficiencies of compressor and turbine affect back work ratio and efficiency of gas turbine?
Inefficiencies in the compressor of a gas turbine cycle increase the back-work ratio and decrease the thermal efficiency of the gas turbine cycle, since they increase the compressor work.
What is the poly tropic efficiency of the air compressor?
it is the eff of thermal and volumetric efforts done on compressor. the bore stroke volume and the clearance volume is isential in this. to run it most ifficiantly one should have knoladge about all
What is the main part of car a.c?
COMPRESSOR, CONDENSER,EVAPORATOR, ORIFICE TUBE, THERMAL EXPANSION VALVE , RECEIVER-DRIER,ACCUMULATOR.
Why you need to check the cooling water level of emergency compressor on a vessel?
since in compressors due to compresion of gas the thermal enery increases.
Where is the low and hi side on a ac compressor?
The inlet side is the low side - this will have the larger hose. On a Thermal Expansion Valve system, this hose will run from the evaporator outlet to the compressor inlet. On a Fixed Orifice Tube system, this hose will run from the accumulator outlet to the compressor inlet. The outlet side is the high side, and the hose will run from the compressor outlet to the condenser inlet.
Which port is the low side on the back of a 89 volvo 244dl compressor?
Follow the hoses. The low side hose will be larger in diameter. If the vehicle uses a Fixed Orifice Tube system, it will go from the accumulator outlet to the compressor inlet. If it has a Thermal Expansion Valve system, it will go from the evaporator outlet to the compressor inlet.
What is the effect or reheater in the gas turbine?
1.Turbine output is increased for same compressor work. 2.As more heat is supplied,thermal efficiency decreases.
What caused the AC to stop working on a 1993 Lexus SC300 when there is not 12V on the compressor and the thermal fuse is melted?
check the a/c clutch when those go out the whole system shorts out
What consist of one or more sensing elements integral with the motor compressor and an external control device?
A Thermal Protector National Electrical Code, Article 100, Informational note
