The answer is winch
The answer is winch
There are two general forms: - a wheel attached to a fixed axle which rotates in a frame or mount - a wheel which has a hole in its center and revolves around an axle passing through it. In the first, lubrication can be applied to the mounting bracket where it holds the axle. In the second, lubrication is applied to the axle (shaft) where it passes through. This can also include ball bearings that distribute the weight and themselves roll within a mounting.
spinal cord stroke
The cord
Inflammation of the spinal cord is called Myelitis.
take your cover off of the pull cord, there should be a slot in the wheel that turns your crank, take your cord and tie a knot at the end of it a slip it in the slot wind the cord around the wheel bolt cover back on go have some fun....
There is no unit of measure called a cord.
the bone that is also called the spinal cord
1. Raise Motorcycle so front wheel is just raised off the ground. 2. Inspect wheel bearing end play and service bearings if necessary. 3. Remove brake caliper. Support caliper using a rubber bungee cord. NOTE Do not operate front brake lever with the front wheel removed or the caliper piston may be forced out of piston bore. Reseating the piston requires disassembly of the caliper. 4. Remove axle nut, lockwasher and washer. 5. Loosen the slider cap screws and pull the axle free. 6. Remove wheel from forks.
Umbillical Cord
Spinal cord therapy
That would most likely be a pulley. A pulley is essentially a wheel on an axle that usually has a groove in the middle of its circumference that holds a rope, cable, belt, or chain. Pulleys are used to transmit motion rotationally and apply force in the direction of said motion. Two or more pulleys makes a tackle. Hope this is what you were looking for.