A selector switch is normally used in a place to avoid 3 ammeters usage and instead measuring current in all the 3 phases using 1 ammeter only.
Motto: SAVE MONEY.. :D
The selector switch provided for ammeter is to check the amount of current taken from each phase supply. (ie) R,Y and B. Each phase supply should be covered with a current transformer with the rated amps capacities. The two leads of the the each phase CT are connected to the respective leads in the selector switch of the ammeter.
aryton shunt in a multirange ammeter is basically a bunch of resistors(shunt) connected together in parallel to the Dc ammeter and a selector switch in order to basically extend the range of the current...
there is a symbol of bulb,galvanometer,voltmeter,ammeter,gong,paperclip,switch,wire,solenoid,bulb and armature
if we take resistance in parallel with ammeter then the range of ammeter will change.
dc ammeter has three connecting pins while ac has four
Micro ammeter has higher resistance. use ohm's law.. Say the voltage applied is 1 V. then for the ammeter.. I=1A, V=1V R=1 ohm for the micro ammeter.. I=0.000001, V=1V R=1000000 ohms
aryton shunt in a multirange ammeter is basically a bunch of resistors(shunt) connected together in parallel to the Dc ammeter and a selector switch in order to basically extend the range of the current...
pickup selector switch
An open switch in a circuit will stop all current flow so the ammeter should read zero amps.
how do i replace the fuel selector switch on the dash of a 1995 ford f250
the bulb will glow and ammeter will show the reading
The selector lever.
RF refers to 'radio frequency'. A selector switch would select a different range of radio frequencies at each of its positions. RF selector switches would be found on short wave receivers and transmitters.
The fuel tank selector switch can be found on the left side of the dash of a 1984 F-150. This is immediately next to the headlight switch.
The vacuum selector switch on a 1999 Chevy Tahoe is located under the dash. It is to the right of the gas pedal.
where is the location of the fuel selector switch on a 2110 4 cylinder ford escape? or fuel selector switch circuit.
It depends what you mean by "third switch" There is a pickup selector switch for each neck. The other one is a 3-way selector switch that allows you to choose which neck is active (12string, both, or 6 string)
Sends power to the selector causing the door inside the unit to open and close swapping tanks.