There are 2 types interrupts in 8085 such as:
1)hardware interrupt
2)software interrupt
The highest priority interrupt in the 8085 is the TRAP interrupt.
No. RST7.5 is a maskable interrupt on the 8085, not the 8086/8088.
There is no exit instruction in the 8085. Do you mean return, as in from a function or interrupt? If so, the instruction is RET.
It is an interrupt having highest priority in 8085
4
The lowest priority interrupt in the 8085 microprocessor is INTR, unless you also consider the software interrupts, RST 0 through RST 7, which are even lower.
The INTA- (Interrupt Acknowledge) pin on the 8085 is an acknowledge of the INTR (Interrupt Request). It has the same timing as RD-, and external hardware is expected to provide an opcode, usually a CALL or an RST instruction, in response to INTA-.
The SIM instruction in the 8085 is Set Interrupt Mask. You can use it to set and clear the three interrupt masks for RST7.5, RST6.5, and RST5.5, as well as to set or clear the SOD (Serial Output Data) pin. You can also reset the pending RST7.5 interrupt, if desired.
RIM is Read Interrupt Mask. It is used to access the interrupt mask register, which contains the status of the three interrupt masks and the serial input data pin.
The peripheral with the highest interrupt priority depends on the hardware and software design of the particular system. In the 8085, the TRAP interrupt has the highest priority. The peripheral connected to TRAP is your choice.
if u want to execute high priority interrupt,at that time of low priority running.So, we can mask the low priority interrupt and execute the high priority interrupt.
In the 8086/8088, the interrupt vector table is the first 1024 bytes of memory. In the 8085, the interrupt vector table is the first 64 bytes of memory if using the RST form of interrupt, otherwise the interrupt vector is provided by the interrupting device, usually in the form of a CALL instruction. The interrupt handler is wherever the interrupt vector points to.