Normal faults are when you have hanging walls that slide down relative to and below the footwall. Dip-slip faults are normal faults.
No. Your terminology is close but not quite right. The three main types of faults are normal faults, reverse faults, and strike-slip faults. Strike-slip faults may also be called transform faults.
The answer is a fault-block mountain
The three major types of faults are normal faults, reverse faults, and strike-slip faults. Synclines are not faults but rather geological structures that describe the folding of rock layers.
Normal faults are caused by tensional stress, which occurs when the Earth's crust is being pulled apart. This causes the hanging wall to move downward relative to the footwall, resulting in the formation of a normal fault.
Faults are created when tectonic plates are stretching or compressing. There are two types of faults which are normal and reverse faults.
Normal faults
The two types of faults that can result in mountains are thrust faults and normal faults. Thrust faults occur when one tectonic plate is forced up over another, while normal faults occur when the Earth's crust is being pulled apart, causing one block to drop down relative to the other.
The three types of faults are normal, reverse, and strike-slip faults. Normal faults are associated with divergent plate boundaries, reverse faults with convergent plate boundaries, and strike-slip faults with transform plate boundaries.
Reverse failts are caused by compression. Normal faults however are formed by tension.
The three types of faults are Normal faults, Reverse faults, and Strike and Slip fault
Normal refers to that the angle of the fault is 90o