0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you know when your cv joint is bad?
I think you mean axle shaft joint. The usual symptom of a bad axle shaft joint is a crunching noise when turning corners.
What is a Constant Velocity Axle Shaft?
a cv joint
What is a huge joint?
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
What is a huge?
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
How can you tell if the CV joint on a 2002 Jeep Grand Cherokee is going bad?
I think you mean axle shaft joint. A crunching noise, especially when turning corners suggests bad axle shaft joints.
What noise does a bad axle make?
A bad cv joint/axle shaft on the front will make a clicking noise when turning.
What is the part between the passenger front axle and the wheel bearing on a dodge 2500 diesel?
Axle shaft u joint or the steering knuckle.
How do you take apart an outer CV joint on a 1998 volkswagen gti vr6?
Once the axle is out, just hold the axle shaft and whack the CV joint with a rubber hammer a few times till it comes off the end of the shaft. It is held on by a spring clip which detents into a groove in the joint body. Cutting off the boot first will help a little.
Rutling noise in a car during hard left or right turns?
bad cv joint aka axle shaft
What causes a leak where the axle meets the transmission on a 1996 Grand Caravan?
Axle shaft seal.Axle shaft seal.
How do you replace a rear cv boot on a subaru wrx?
Lift the vehicle using a jack. Inspect the CV boot for problems. Mark the axle. Separate the CV from the shaft. Remove the CV boot clamps. Use a mallet to knock the CV joint off the shaft. Remove the boot from the CV axle shaft.
Were is the universal joint located?
Rear wheel drive cars, there is one on each end of the driveshaft. 4 wheel drive has a short shaft that runs to the front axle, there is one on each end of that shaft. and each front axle has one on the end behind the wheel.
