Back lash is best described as how much the pinion gear will move before contacting and moving the crown gear.
This is specified and measured on the crown gear.
A rear axle adjustment is also known as a rear axle alignment. The perimeter chassis of the car needs to be measured before a rear alignment is performed.
This would be the exiting of the tailpipes area,ie:behind the rear axle.
In the back of the car near the rear axle....
Only if the rear axle is a drive axle.
When the car backed up and the back wheels slipped into the ditch, the rear axle was damaged.
Yes
Inside the rear axle.Inside the rear axle.
Under rear, in front of back axle.
Pre 1998, it is on the back of the trans/transfer case After 1998, it is the rear axle abs sensor on top of the rear axle.
On the rear axle?
Top of the rear axleTop of the rear axle
Normally a whining noise in the back end means the differential is shot