A T8 LED tube has to be used with a ballast to bring the correct voltage to the tube for it to operate correctly. Removing the ballast from the circuit will prevent the tube from operating.
reactor ballast
choke (ballast),starter,tube light,tuble light socket holder and the tubelight mounting plate
In a T* ballast and T8 bulb more energy efficient then a T12 ballast and a T8 bulb? A:Depends on the CURRENT through the tube. When the Tube is run at 100% of rating, The T12 Takes more CURRENT to give a certain Brightness. Because the surface of the T8 is closer to the ion stream through the tube, it takes less CURRENT to light up the T8 to the same brightness. However, IF you use a T12 in a T8 ballast, you will get LESS CURRENT through the tube, and LESS POWER consumed ALONG with LESS Light.
When the ballast is to be purchased, look at the schematic that is on the label of the ballast. There it will tell you which ballast is good for which lamps and also let you know what length of tube the ballast is good for. Most of the new electronic ballasts allow for multiple connections of different size lamps.
A T8 LED tube has to be used with a ballast to bring the correct voltage to the tube for it to operate correctly. Removing the ballast from the circuit will prevent the tube from operating.
yes..if we replace magnetic ballast with electronic ballast...there is no need of starter if we use electronic ballast.
Due to the problems in the ballast.Replace the ballast.
If you mean the ballast in a fluorescent light fitting where the ballast is wired in series with the tube, the answer is "No". Explanation: If no tube is in place, the light fitting's circuit is "open" so there is nothing to take any current from the "hot" supply wire and return it to the "neutral" wire.
you need to replace a ballast
reactor ballast
choke (ballast),starter,tube light,tuble light socket holder and the tubelight mounting plate
In a T* ballast and T8 bulb more energy efficient then a T12 ballast and a T8 bulb? A:Depends on the CURRENT through the tube. When the Tube is run at 100% of rating, The T12 Takes more CURRENT to give a certain Brightness. Because the surface of the T8 is closer to the ion stream through the tube, it takes less CURRENT to light up the T8 to the same brightness. However, IF you use a T12 in a T8 ballast, you will get LESS CURRENT through the tube, and LESS POWER consumed ALONG with LESS Light.
No, a fluorescent light fitting with a 4xT8 2' 18W tube and a 48W ballast does not use all the 120W when running.
When the ballast is to be purchased, look at the schematic that is on the label of the ballast. There it will tell you which ballast is good for which lamps and also let you know what length of tube the ballast is good for. Most of the new electronic ballasts allow for multiple connections of different size lamps.
Yes a T12 lamp socket will take a T8 tube. The T8 tube will not operate. The T8 ballast is an electronic ballast where as the T12 ballast is a magnetic type. If you are changing over fluorescent fixtures to the smaller T8 lamps then the ballast has to be changed and the end sockets have to be rewired. The schematic on how to do the rewire is on the electronic ballast's label.
For information about fluorescent tube lights see the answers to the Related questions and the Related link shown below.