bit rate is half the baud rate
Ethernet indicates 10 Mb by definition. It used Manchester encoding. This encoding manages timing within each bit. FastEthernet is 100 Mb and uses a combination of 4b/5b and MLT-3 encoding, over 2 pairs. Gigabit Ethernet uses 8b4qt (?) and PAM-5 I'm not sure I got all this right, but here are the details as I understand them: 10 BASE T is Manchester encoding - Basically, this means that each symbol is either a transition in the middle of the bit time from a 0 to +v (a 1) or a transition in the middle of the bit time from +v to 0 (a 0). 100 BASE T uses a combination of 4b/5b encoding to prevent a string of 1s or 0s from causing a loss of timing and MLT-3 signalling to allow the same information to travel at a slower frequency. 1000 BASE T uses a combination of 8b4qt (?) (this is 8 bits, separated onto 4 quernary signals that carry 2 bits each), and PAM5 signaling (a 5 voltage-level signal that effectively causes a transition at each signal and 4 possible states, signalling 2 bits).
Differential Manchester
The bandwidth of the transmission media The modulation encoding used
in optical fiber WDM technolgu is used how wavelength coverts into data rate
Gigabit Ethernet is the term used to describe the transmission of Ethernet frames at a rate of one gigabit per second. It started being used in early 1999.
Differential Manchester
What encoding scheme is used by the 802.11a and 802.11g standards but not by the 802.11b standard?
Ethernet is the most popular networking technology used in LANs. Fast Ethernet is used to refer to any version of Ethernet that meets or surpasses the 100 Mbps transfer speed.
Arpa encapsulation must be used to enable Ethernet II frame type on your Ethernet.
Matrix encoding circuit.
An ethernet cable is used in computer and internet connections and is available in different lengths and is also called an Ethernet Cable
ethernet cable, ethernet hub, crossover cable, router