Bulking of sand means increase in it's volume due to presence of surface moisture . The volume increases with increase in moisture content . The volume may increase up to 20 to 40% when moisture content is 5 to 10 %.
Due to moisture in each particle of sand, sand gets a coating of water due to surface tension which keeps the particles apart. This causes an increment in volume of sand known as Bulking.
- Edited by KASEE SREENIVAS# Hindustan Construction Company
The maximum bulking of sand is in 13% to 14% moisture content. It's likely to be 13.8% moisture content.
Plastering sand is find sand screened to suit the plaster coarse i.e. base coat or finish coat. For finish coat very fine sand is used. Sand for concrete is not sived if pebles are not present. Both sand shall be sweet sand, if from sea it has to be washed before use.
Fine sand is best for mortar.
Not just any sand. Mortar sand. Mortar sand is a larger grain sand that has been washed and screened to remove any rocks or pebbles.
Shear strength of fine sand is determined by the angularity of the sand particles, the grading of the sand. These two features governs the critical state shear strength parameters of the sand. Density, however, dictates the peak shear strength of the sand. i.e. the denser the sand, the higher the peak shear strength. But the critical shear strength remain the same. The denser the sand, the lower the void ratio. Shear strength of fine sand is determined by the angularity of the sand particles, the grading of the sand. These two features governs the critical state shear strength parameters of the sand. Density, however, dictates the peak shear strength of the sand. i.e. the denser the sand, the higher the peak shear strength. But the critical shear strength remain the same. The denser the sand, the lower the void ratio.
by replacement method
The maximum bulking of sand is in 13% to 14% moisture content. It's likely to be 13.8% moisture content.
10%
Bulking of sand means increase in it's volume due to presence of surface moisture . The volume increases with increase in moisture content . The volume may increase up to 20 to 40% when moisture content is 5 to 10 %.Due to moisture in each particle of sand, sand gets a coating of water due to surface tension which keeps the particles apart. This causes an increment in volume of sand known as Bulking.
Bulking is the muscle-gaining phase.
yes
creatinine
a steroid for getting cutt instead of bulking.
a steroid for getting cutt instead of bulking.
Fat provides fluidity.
David Jenkins has written: 'Manual on the causes and control of activated sludge bulking, foaming, and other solids separation problems' -- subject(s): Activated sludge process, Flocculation, Purification, Sewage, Sludge bulking
Flavouring,colouring,bulking agents are some of the food additives.