Low RPM. Gear is too high for travel speed
No
If would not be bad for a car engine to shift from third to second gear if you are traveling at 30mph.
When the engine revvs up to about the 5 on the RPM gauge in fifth gear.
you need to install idler gear or remove idler gear depend on the engine to counter the direction also you need to change the engine oil pump direction and you need to change the cam shaft directions
i am trying to fiind out how often do you change the gear case oil on a 150cc scooter, i dont want to know about the engine oil just the gear case oil
Change the differential gear ratio and/or increase the horse power of the engine.
because you are engaging the clutch which cuts out the engine for a smooth gear change
manual stick shift BMW what cause to shke when i change in to the first gear
no the gear stays in place , unless you take the timing gear cover off + the bolts that hold it to the cam shaft.no it won't change the position either unless you crank the engine, the gear stays in place.
Gear changes are determined after how fast the engine is turning. For each gear there are set limits for which engine revs that are allowed. if the revs go high, the transmission changes up a gear, if the gears go low it drops down a gear.
The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.
Yes, quite easily. It is highly unlikely to cause any damage