It's advisable to clean and lube your clutch after every ride or two - depending on the conditions. If you drive a lot of trails/sand/dusty conditions, its best to do it every ride, but if you're mostly on the street every 3-5 times would be fine.
Your clutch could be worn out, but you can try to clean and lube it and see if that takes care of it. Otherwise, max-torque and comet clutches are widely available for it.
With the engine off, and cooled down:
Remove the Clutch Cover
Blow out the clutch with compressed air (from an air compressor)
Oil the clutch BEARING with a few drops of oil.
MAKE SURE OIL DOES NOT GET IN THE CLUTCH
Roll the mini bike around to get oil throughout the bearing surface.
Install Clutch cover. Try to ride!
If that doesn't work, just get a new clutch - should be about $25-30 shipped.
Check the link I added in the "Related Links" area. It's an assembly video, and pre-ride instructions (what to check, etc) for the Baja Motorsports Doodlebug DB30
yes it is
remove the governer, or adjust it. this will cause it to be unrestricted and will go alot faster, however it could also cause the engine to blow if you over rev it for an extended period. just be careful with it and listen to the sounds of the engine and you will be fine.
Baja California is part of Mexico. The Baja is actually divided into two states: Baja California Norte(north) and Baja California Sur(south). Baja California is part of Mexico. The Baja is actually divided into two states: Baja California Norte(north) and Baja California Sur(south).
20-25 mph max take the two middle gears off and make one chain from clutch to rear wheel and you can go 50 :D
flordia is not and baja is
Mexico
English word for Baja Ms.
u have to remove the transmission cover and remove the clutch inside. then temove both of the connecting parts of the belt it is possible to do just one though and put it on and re assemble
No it is quite warm in Baja California.
Baja Mar was created in 1975.
Ethmia baja was created in 1973.