0
Code 7 2 is catalytic converter efficiency below required level
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you take the engine out of a 1996 Plymouth breeze?
Engine and trans out the botom at the same time.
When was Plymouth Breeze created?
Plymouth Breeze was created in 1996.
What is the engine oil capacity for a 1996 Plymouth breeze 2.0 liter?
5 quarts
Does a 1996 Plymouth breeze have a detachable bell housing?
No
Where are the drain plugs on a 1996 Plymouth Breeze?
Which drain plugs?
Why does a 1996 Plymouth breeze start and run until it gets warm then stalls and wont start again until it cools off?
A 1996 Plymouth Breeze that starts and runs until it warms up, but then stalls might have a problem with a temperature sensor. The sensor is telling the computer that the temperature is too high for the engine to operate safely. Check the Electronic Temperature Sensor or the Manifold Pressure Sensor (MAP).
Where is crankshaft sensor located on 1996 Plymouth breeze?
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
Where is the ac high pressure switch on a 1996 Plymouth breeze?
It is located on the discharge side of the compressor. On a 2.4L engine you will need to jack the vehicle up to get to it.
Why does the 5 20 amp fuse keep blowing on your 1996 Plymouth Breeze 2.0?
You need to get a service manual and check that circuit for a short to ground.
How do you set the timing belt on a 1996 Plymouth Breeze 2.0L?
Get a manual on your car.
What weight of motor oil does your 1996 Plymouth breeze use?
5w305w30
Is the 1996 plymouth breeze 2.0 liter an interference motor?
yesyes
