P0016 - Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
symptoms
The engine may turn over but not start up
The engine may rattle near the harmonic balancer which means that the tone ring is damaged
The engine may start up and run, but run rough
cause
Timing chain is stretched, or timing belt skipped a tooth because its worn
Timing belt/chain not aligned
Tone ring on the crankshaft slipped or broken
Tone ring on the camshaft slipped or broken
Faulty crank sensor
Faulty cam sensor
Bad wiring to crank or cam sensor
Timing belt or chain tensioner faulty
The fix
Check the cam and crank sensors and their wiring for damage. If you see broken/frayed wires, repair.
If you have a scope, check the cam and crank patterns. If a pattern is missing, suspect a bad sensor or a slipping tone ring.
Remove the cam gear and crankshaft balancer and tone rings for proper alignment, make sure they're not loose or broken and they haven't sheared the alignment key. If they are correctly installed, replace the sensor. If the signal looks normal, then check the timing chain/belt for proper alignment. If it's not aligned, check for a damaged tensioner.
Also check that the belt or chain isn't stretched. replace and recheck.
Crankshaft position correlation with camshaft position.
Either the cam or crank sensors have failed.
Crankshaft position correlation with camshaft position.
Either the cam or crank sensors have failed.
Crankshaft position correlation with camshaft position.
Either the cam or crank sensors have failed.
It is in the fuel tank.
A 2005 5.9L Cummins is what fits.A 2005 5.9L Cummins is what fits.
11.5-1211.5-12
the 2005 Dodge Cummins stock horsepower is 325
6+ hours6+ hours
Ask your dealership for a 2006 diagram for the same vehicle.
325
Front of the passenger side of engine. Look up and behind the ac compressor.
i know with diesel engines if you run out of diesel, or change any part of your fuel line you will need to bleed your injectors to get it to run. you may have to bleed them all before it will run.
12 quarts
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.
325 Hp 610 Tq