Want this question answered?
The oldest extant blast furnaces were built during the Han Dynasty of China in the 1st century BC, that's pretty interesting if you ask me. And of course the fact you get a 'SLAG' at the end.
The problems that iron impurities can cause in a blast furnace can include the iron not melting down correctly, obnoxious fumes being created, and the impurities could ruin an entire batch of melted iron.
A gas furnace is a furnace that operates to keep your house warm with the use of gas. Gas furnaces are very energy efficient furnaces, and are the most common furnaces used in North America.
Black sand beaches and deposits are common in all of the trans-Pacific countries with volcanoes. The sand is black because of the iron component, derived from the volcano, and this is a trade-able commodity used in steel making. Black sand is mined in New Zealand and sent to Japan for steel-making, but not just for the iron component. The sand also contains titanium as a contaminant and this makes the steel-melt in the furnace somewhat sticky - normally a disadvantage. But this stickier component adheres to the ceramic lining of the blast furnace, and thus prolongs the life of the furnace lining. Steel furnaces require re-lining at intervals, but this is an expensive process, as the furnace has to be pulled out of commission, and allowed to cool before the refractory lining can be replaced. Thus the titanium contaminant is an economic advantage.
Although wood is very common, coal lasts forever on a torch and lasts longer in a furnace.
Limestone, dolomite, BOF slag, electric furnace slag, olivine
Blast furnace = Hochofen
A blast furnace is used to extract iron from its ore.
Its because air is forced into the furnace to increase temperature. Steve.
Govăjdia Blast Furnace was created in 1810.
A blast furnace is a forge in which ore is smelted to meal, being intensified by a blast of hot air.
'i' blast furnace of tata steel, jamshedpur,india
through the top of the blast furnace
A blast furnace.
iron is collected from blast furnace by drilling the taphole.Taphole is a hole drill and plug after cycle of time located in blast furnace bottom.
Useful Volume of Blast Furnace is the volume of the furnace from the throat level to the level where the taphole is placed. This is known the way basically because that is the region where the useful products from Blast furnace are present.
A blast furnace runs continuously, and input materials are continually dumped in at the top to make their way down through the furnace. Shutting down a blast furnace for relining or other work is a major event in its life.