0
In simple terms a short circuit is when negative & positive
come together I:E a cable (positive)that is frayed touches the ground (negative).
A short circuit is also known as a dead short.
An example of an overload might be.
If the wiring in your car headlights was rated at 20 Amps & you
wired driving lights into that circuit, the Amperage draw would go up to 40 Amps
Causing the fuse to blow, or if the circuit was unfused, the wiring to burn out.
What else can I help you with?
Which cell is damaged by short circuiting?
Any cell may be damaged by short-circuiting.
What is meant by thermocouple short circuiting?
Thermocouple short circuiting refers to an unintended electrical connection between the two dissimilar metal wires that form a thermocouple, which can lead to inaccurate temperature readings. When the wires touch or are connected improperly, the thermoelectric voltage generated by the temperature difference is disrupted, potentially resulting in a reading of zero volts or erroneous temperature values. This can occur due to physical damage, insulation failure, or poor connections. Proper installation and regular maintenance are essential to prevent short circuiting and ensure accurate temperature measurements.
Are vitamins bad for epilepsy?
Epilepsy is a short circuiting of parts of the brain. There is no know connection between vitamin intake and grand mal seizures.
Why is a fuse wire necessary in a circuit?
a fuse wire melts when current passing through it exceeds a certain value as in overloading and short circuiting .this breaks the circuit prventing further current flow and damage ..
Why vertical polarization cause short circuiting in receiver?
Why vertical polarization not working in receiver
Will a battery explode when short circuiting the battery?
Yes it could over heat and explode. Don't do it.
Why are conducters used in domestic wiring insulated?
Wires are insulated to stop a short circuiting between the common neutral wire and the wire that supplies the potential voltage to the load of the circuit.
What is difference between short and near jumps in Intel Microprocessors?
difference between short,near and far jump
What is ment by the term short circuit?
Short circuiting means providing a low resistive path, diverting maximum current away from where it was intended to go.
What is the recommended stickout for short circuiting metal transfer?
The recommended stickout for short circuiting metal transfer in GMAW is typically around 1/4 to 1/2 inch (6-13 mm). This range helps ensure optimal welding parameters and bead appearance by controlling the distance between the contact tip and the workpiece. Adjusting the stickout within this range can help achieve better welding performance and quality.
What is the difference between a short- and long-term goal?
the long term is different between a short term because the short
What the difference between short sighted people and short sighted people?
nothing
