0
90 degree
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you get the center of elbow?
Formula for calculating center to end distance of such elbows is as follows: For 90° Long Radius elbows, center to end dimension given in dimension tables of ASME B16.9 is same as radius of elbow. This is because Tan (90/2) i.e. Tan 45 is 1. Normally custom elbow angles from 45 degree to 90 are cut from 90 degree standard elbow. If that's what you were asking about...
What is the take off for a half inch screwed 90 degree elbow?
1/2 inch
What is the take out of a 6 inch short radius 90 degree elbow?
4 1/2 inch
What is the take off of a 90 degree elbow with 1 inch diameter?
2 inches
How many cm are in a standard inch?
1 inch = 2.54 centimetres.
How long is an inch in center meters?
1 inch = 2.54 centimetres
What are standard margins?
The standard margins for a Word document are 1 inch at the top and bottom of the page and 1 ¼ inch from the left and right hand sides of the page.For formal pepers, many teachers want 1 inch on every side.
Which are the standard types of floppy disk drives?
3 1/2 inch 5 1/4 inch 8 inch
How do you calculate the center of a 90 degree pipe elbow?
If your elbow is a short radius it is 1 times your nominal pipe diameter. If it is a long radius it is 1 1/2 times your nominal pipe diameter.show me the exact pattern of long radius
What is standard dice recipe?
about a 1/4 inch x 1/4 in. cube.
Surface area of elbow?
The formula for the surface area of an elbow (or 90° angle) is (pi^2 * (radius2^2 - radius1^2) ) / 4. Where pi = 3.14159, radius 2 = the radius from the center to the outside, and radius 1 = the radius from the center to the inside.
What as 8.5 mm in standard size?
About 0.33 (1/3) inch.
