0
Feeders are commonly used to supply power to or from a radio antenna. A feeder can be a pair of parallel wires with closely controlled spacing (twin-wire feeder), or a single wire inside a hollow cylindrical conductor (coaxial feeder.
<<>>
In Canada the electrical term "feeder" is usually used incorrectly as a substitution for the terms wire or conductor. It is correctly defined is, any portion of an electrical circuit between the service box or other source of supply and the branch circuit over current devices.
In the U.S. of A, a feeder definition taken directly from the National Electrical Code: All circuit conductors between the service equipment, the source of a separately derived system, or other power supply source and the final branch-circuit overcurrent device.
Wiki User
∙ 10y ago
Wiki User
∙ 12y agoThe feeders run along streets overhead (or underground, in some cases) and power the distribution Transformers at or near the customer premises.
Add your answer:
Earn +20 pts
What is a North Sea Feeder beginning with the letter Y?
yser
A laccolith is an example of a?
A concordant (lateral) intrusion of magma (which has a dyke-like feeder and a convex (arching) upper surface.
Is plasma a gas with an electrical charge?
Yes, a plasma is a gas with an electrical charge.
What is electrical layout diagram is?
A digram that shows the layout of something electrical
What is electrical stimulation for?
who administers electrical stimulation for spinal cord injury
What is difference between feeder and grid?
In an electrical power transmission system: the grid is what the feeder feed into.
Where is a Bus bar in a circuit?
Where there is an electrical connection required from one feeder to many feeder , then you need a reference or grid from where the loads can be distributed.
How many feeder you can use for chiller?
One feeder will do the job. The definition of a feeder in the electrical trade is a set of conductors that supply a source to a load. The sizing of the feeders will depend on what the load current is. The wire count of the feeder will be dependant upon whether the load is single phase or three phase.
What is incomer in electrical panel?
power entering to power panel from the feeder is called incomer powersupply
What does mcc stand for?
One description for mcc is motor control center. It is an electrical panel or cubicle which houses the one electrical incoming feeder several outgoing power feeders.
What MCC stands for?
One description for mcc is motor control center. It is an electrical panel or cubicle which houses the one electrical incoming feeder several outgoing power feeders.
How do you calculate the feeder size for two or more three phase air condition?
Feeder sizes are based on the amperage of the connected load. Once that is found there are tables in the electrical code book that state what the wire size is for that particular amperage.
What is feeder pillar?
feeder pillars are used for distribution of electrical supply to customer in which having a such arrangement that the Incomer with Protection (MCB, SFU,MCCB) from this protection the O/G is connected to the Bus bar and from bus bar the O/G are provided to customer,
Would a ten foot piece of electrical conduit attached to the peak of a shed acting as an extension for a bird feeder attract lightning?
i want an answer
How you check the stability of the cable feeder?
To make sure that a feeder cable is secure it must be supported. The support distance is stated in the electrical code book. The code also gives support of cable trays, conduit and all the different ways to support cables.
What are the lemon sharks techniques?
the lemon shark is a bottom feeder that uses its Ampullae of Lorenzo to pick up the electrical pulses given out by possible prey
a bird feeder?
a bird feeder !!!!!!
