In an electrical power transmission system: the grid is what the feeder feed into.
The busbar is used as a conductor and is used as a connection between the parallel and the feeder. The feeder is the supply, and it handles the relays.
There is no tapping from the feeders. In other words, the current loading of a feeder is the same along its entire length.Various tappings are taken from the Distributors. Hence, a distributor has distributed current loading along its entire length.
Think of a river getting fed by streams and creeks. These feeders increase the water flowing in the river like electrical feeders increase the current in the transmission line.
Definition from the National Electrical Code Article 100:Feeder. All circuit conductors between the service equipment, the source of a separately derived system, or other power supply and the final branch-circuit overcurrent device.Branch Circuit. The circuit conductors between the final overcurrent device protecting the circuit and the outlet(s).
The voltage of the French National Grid is 2000 mw high voltage. It is a direct current electrical interconnector between the British and French transmission.
The busbar is used as a conductor and is used as a connection between the parallel and the feeder. The feeder is the supply, and it handles the relays.
A "feeder" is just another name for a hopper. The correct term is "hopper"
Where there is an electrical connection required from one feeder to many feeder , then you need a reference or grid from where the loads can be distributed.
This is a home work my friend:)
The home system is purely that: it serves only the single house. A solar grid system would feed the national grid.
An area reference is a general location indicated on a map, such as a city or region, while a grid reference is a specific point identified by intersecting lines on a grid system, such as latitude and longitude coordinates or a military grid reference system (MGRS). Essentially, an area reference gives a broader location, while a grid reference pinpoints a precise position within that area.
A top feeder is easy to differentiate from a bottom feeder because of there mouth bottom feeders will also suck things in the tank. You can tell the difference between a middle and a top feeder because of where they swim most of the time like cardinals and angel fish.
The difference between smart grids and smart microgrids is scale, the types of decision makers and the potential rate of change. While smart grids take place at the utility and national grid level, involving the large transmission and distribution lines, smart microgrids are smaller scale, require fewer decision makers and have faster implementation.
i think basketball
The range is the difference between the largest and the smallest number in a list of numbers. (usually a larger number.)An interval is the difference between two plotted coordinates on a grid. (usually a small number.)
Read the percentages on the label.
-- Square the difference between their 'x'-values. -- Square the difference between their 'y'-values. -- Add the two squares. -- Take the square-root of the sum. The result is the distance between the points.