Think of a river getting fed by streams and creeks. These feeders increase the water flowing in the river like electrical feeders increase the current in the transmission line.
The feed line is the cable or other transmission line that connects the antenna with the radio transmitter or receiver
In a power system, a "radial feed" is one where a source is only present at one end of the transmission line. If a source of power is present at both ends, it is said to be a networked line.
Yes. Because... If we connect an alternator to a transmission line of high capacitance the line voltage will increase and caused a line voltage difference, which does not satisfied the condition of parallel operation of same voltage rating. [By Akhtaruzzaman08]
A ruling span refers to the distance between two adjacent transmission line supports, such as poles or towers. It plays a critical role in determining the overall stability and performance of the transmission line. By optimizing the ruling span, engineers can ensure that the line can safely and efficiently carry the required electrical load without sagging or experiencing excessive tension.
If I'm interpreting the question accurately, a "line isolator" is an insulating standoff for transmission or distribution cable. A bus isolator is an insulating standoff for tubular or bar bus as is normally seen in a substation switching yard.
The feed line is the cable or other transmission line that connects the antenna with the radio transmitter or receiver
The essential difference between a transmission line and an ordinary network lies in their respective purposes and functions: Transmission Line: Purpose: A transmission line, in the context of telecommunications or electrical engineering, is primarily designed for the efficient long-distance transfer of signals, data, or electrical power from one point to another. Characteristics: Transmission lines are engineered to minimize signal loss, distortion, or power dissipation over extended distances. They often operate at high voltages or frequencies to maintain signal integrity.
Each of the three conductors of an electricity transmission system are termed 'line conductors', and there is a potential difference between each pair, called a 'line voltage'. The conductors themselves carry load currents called 'line currents'.
Yes there is a large difference between the two. A line has no end and a line segment ends.
What is the difference between a trend line and a line of best fit
In a power system, a "radial feed" is one where a source is only present at one end of the transmission line. If a source of power is present at both ends, it is said to be a networked line.
its difference
The difference between a perpendicular line and a parallel line is that a perpendicular line crosses or joins, while a parallel line doesn't touch at all.
There is no difference...same thing
A feeder is 'isolated' when it is disconnected from the main line using a switching device ('isolator') with a visible break.
explain the differences between a point and a line and a plant
The starting current is about 30 % of the direct-on-line starting device. The starting torque is about 25 % of the direct-on-line starting torque. The stress on an application is reduced compared to the direct-on-line starting method.