0
What else can I help you with?
Physics numerical four capacitors each of 2micro farad are connected in such a way that the total capacitance is also 2 micro farad show what combination gives this value?
In order to connect four 2 microfarad capacitors such that the total capacitance is still 2 microfarads, connect two pairs of capacitors in series, and then connect the pairs in parallel. It does not matter, since all four capacitors are equal in value, if the center point is connected together or not.
How do you connect a trimmer capacitor?
Trimmer capacitors are used to calibrate (trim) the capacitance in a circuit. They are connected in parallel with some other capacitor, and the circuit is calibrated by observation of response to known stimuli. Since trimmer capacitors are often used in RF circuits, it is generally not possible to make measurement of the capacitors out of circuit because parasitic capacitance at RF is not negligible. Additional question received on April 6th: "I have a 3 terminal trim cap; 2 terminals read continuity, the other not. My question is how do I connect this in a circuit?" In all probability, the two terminals that read continuity are the same terminal, and are simply provided to give three point mechanical stability when soldered into a circuit. You would connect the two terminals that do not have continuity, using either of the terminals that do have continuity, across the capacitor that needed to be "trimmed".
What wire do I connect the 277 VAC wire to?
It depends on what 277 volt device you are trying to connect.
How do you connect a 230V lamp to a 415V supply with no neutral?
Theoretically, you could connect three identical lamps in star (wye) and connect this to the three line conductors. But as you asked how to connect a (single) 230-V lamp to the supply, then the answer is by using a step-down transformer.
How to connect 3 phase power factor correction capacitor?
how to connect power capacitor with 3 phase motor
Why is it dangerous for connect an alternator with high capacitance transmission line?
It is dangerous because with capacitive load line voltage will increase which cause the line voltage difference and it will not satisfy the parallel operation of the same voltage rating.
How do you connect the wire from the alternator to the starter?
how do you connect the wire from the alternater to the starter?
How do you replace the alternator on a 1993 Buick Roadmaster?
Disconnect the battery. Remove the alternator belt. Disconnect the wiring on the alternator, then unbolt and remove the unit. Bolt the new alternator in place and connect the wiring. Install the belt and connect the battery back up.
How do you connect a dc amp meter to the alternator and battery?
in series to the battery from the alternator following polarity
Why connect capacitor to alternator?
To help produce voltage.
How do you connect the wires to the alternator on a John Deere engine model 4045TF150?
What kind alternator is? Is Bosh or different kind?
Remove and replace alternator on Chrysler cirrus?
disconnect the battery. Remove the alternator belt then disconnect the wires. Unbolt the alternator and remove. Bolt the new alternator in then connect the wires, belt, and battery.
I have the alternator just missing the wiring connection sheet how do you connect an alternator from a generator on a 12 volt system?
You wouldn't. Terminology wrong? An alternator is a generator that generates AC.
Where do you connect the positive battery lead to the starter or the alternator?
Starter solenoid.
What does the harness connector of an alternator connect to on both ends?
plus and ground
Can you connect 7 alternators parallel?
why in parellel .of alternator connected in parellel
How do you hook up an alternator in Chevelle?
To hook up an alternator in a Chevelle, first ensure the battery is disconnected for safety. Connect the positive terminal of the alternator to the battery's positive terminal, and the negative terminal to the car's ground. Then, connect the field wire or the voltage regulator wire to the appropriate terminal on the alternator. Finally, secure the alternator properly and reconnect the battery before testing the system.
