0
What else can I help you with?
How do you connect the alternator positive and negative wire to starer?
You do not connect any wire from the alternator to the starter. The positive wire from the alternator should run to the positive on the battery, and the negative wire (if equipped) should run to the engine block (or any suitable ground). Most alternators are already grounded by the bolts holding them to the engine, but some do have a negative wire.
Is there a wire between starter and alternator?
No.
Where do you connect the positive battery lead to the starter or the alternator?
Starter solenoid.
How do you replace battery cable?
You have to disconnect the ground wire from the block. You have to disconnect the positive wire from the starter and the alternator and the powerline going to the fuse box. and connect the new ground then the positive
What does the purple wire on a starter connect to?
It is the ignition wire. The purple wire goes to the small stud on starter.
What is a proper way to connect a second starter wire?
The proper way to connect a second starter wire depends with the configuration used.
Where do you locate the fusible link for the alternator on a 2005 Chevy Malibu?
It's located on the end if the main power wire coming off the alternator. This wire connects to the starter. The fusible link is located on the starter end of the wire.
Is the battery connected to the alternator?
Indirectly. The positive cable on the battery is hooked to the starter. The other wire on the starter post goes up to the alternator.
What wire hooks from battery to alternator?
the positive wire that recharges the battery after being drained from the starter
How do you wire up an alternator for a 1977 dodge van with 5.9 liter?
To wire up an alternator for a 1977 Dodge van with a 5.9-liter engine, first, disconnect the battery to ensure safety. Connect the alternator's positive terminal to the battery or starter solenoid with a heavy gauge wire, and attach the negative terminal to the engine block or chassis ground. Next, connect the field wire (often a small gauge wire) from the alternator to the voltage regulator, ensuring proper connections according to the wiring diagram specific to your vehicle. Finally, reconnect the battery and start the engine to check for proper charging voltage.
What side of the starter does the wire that comes from the alternator go to positive or negative?
Positive
Where do I connect the starter's negative wire from the starter to?
Connect it to one of the mounting bolts or the engine block. Match the size of the connector to a nearby bolt on the block.
