answersLogoWhite

0

Each of the three conductors of an electricity transmission system are termed 'line conductors', and there is a potential difference between each pair, called a 'line voltage'. The conductors themselves carry load currents called 'line currents'.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the maximum transmission speed for fiber optic?

The maximum transmission speed for fiber optic is about 186000 miles per second. Wires are a bit slower because of transmission line effects


Why transmission lines are thicker than TV cable wires?

Transmission lines are thicker than TV cable wires because the transmission lines are used to transmit both low freq and high freq signals. And the losses of the transmission lines depend the resistance of the line which inturn depend upon length and area. As we have to transmitt the signals over long distances the transmission lines are thicker in size.Whereas in TV cable wires the construction is totally different in which transmission of signals is in between two conductors thereby avoiding losses.Therefore there is no necessity for these lines to be made thicker. That is why transmission lines are thicker than TV cable wires.


What is the function of the wire cutter?

use to cut wires piste


Why transmission line does mot have neutral?

Neutral and Ground are the same thing, so it would just be two wires serving identical purposes.


How many wire are used in transmission line?

Transmission lines are three-phase systems. There are three line conductors in a three-phase system. However, to reduce electric stress at higher voltages, these lines are frequently made up of 'bundled' conductors -so each line might have two, three, or four separate conductors. In addition, transmission towers usually carry separate circuits -i.e. separate three-phase circuits on opposite sides of each tower. So, in the UK for example, a typical 400-kV transmission line will consist of two, separate, three-phase circuits suspended on each side of each tower, with each line consisting of four bundled conductors. That's 24 conductors.


Why twisted pair of wires is used in instrumentation?

Because, from total 8 wires 4 wires are used for actual data transmission ( i e for bit transmission ) and remaining four wires are wounded to these wires to avoid crosstalk and radio frequency interference (RFI).


How do you change transmission line?

how to fix a transmission without taking it a part how to fix a transmission line


What is a transmission lines?

An AC transmission line is typically a set of three wires that transports electricity over great distances at potentials exceeding 115,000 Volts. A common intrastate transmission line voltage is 230,000 Volts (230 kV), and interstate lines are normally rated 500,000 Volts (500 kV). When it is desired to transport electricity to a non synchronized area -- like Texas, DC transmission lines are used instead.


What is the function of balancing line in a centrifugal pump or compressor?

The balancing line is a transmission line consisting of two conductors of the same type, that are grounded to the compressor's circuits and to the ground and helps keep external noise down.


What is a function that forms a line when graphed called?

It is a continuous function. If the line is a straight line, it is a linear function.


Do you get DC current directly from the transmission line?

Only if it is a DC transmission line.


Can an electronic 350 transmission be used without the wires?

no