The balancing line is a transmission line consisting of two conductors of the same type, that are grounded to the compressor's circuits and to the ground and helps keep external noise down.
Turndown: The allowable operating range for the centrifugal compressor between the design point and the surge line at any given speed for a fixed compressor head.
for thrust balancing.
centrifugal pump uses centrifugal action while reciprocati pump operates on resiprocating motion of pistonA centrifugal pump will typically give you a higher flow rate but a lower pressure, where a piston pump will give you more pressure but a lower flow rate.
Axial fans are like a propeller - like most domestic fans. Centrifugal fans are like water or paddle wheeels that sit inside a case. Instead of water turning them, the wheel is driven by the motor and that moves the gas. In-line merely means that the fan sits in the gas flow.
A refrigeration circuit is provided with a quench line connecting the liquid line and the suction line and containing a QEV. The QEV is controlled responsive to the superheat of the refrigerant supplied to the compressor. By injecting liquid refrigerant downstream of the suction modulation valve and the sensor for the TXV, the system can be operated at low capacity without overheating the compressor oil.
test
Turndown: The allowable operating range for the centrifugal compressor between the design point and the surge line at any given speed for a fixed compressor head.
for thrust balancing.
centrifugal pump uses centrifugal action while reciprocati pump operates on resiprocating motion of pistonA centrifugal pump will typically give you a higher flow rate but a lower pressure, where a piston pump will give you more pressure but a lower flow rate.
Yes, the discharge line from the compressor can be hot.Yes, the discharge line from the compressor can be hot.
the big line is the suction for the the compressor in the A/C unit, The small line is the compressor discharge that goes to the furnace
The suction line connects the evaporator outlet and the compressor intlet. Low pressure refrigerator vapour is drawn from the evaporator to the compressor through this line.
Discharge line is the line in which the refrigerant passes through after being discharged by the compressor. Liquid line is the line located after the condenser, following refrigeration cycle. Suction line is the one that the referigerant is sucked :) in, to enter the compressor.
It is a continuous function. If the line is a straight line, it is a linear function.
The expression for centrifugal force is m v2 / r. For a straight line radius of curvature r is infinity. So the centrifugal force will become 0 as 1/infinity = 0
The larger line is suction. The larger line is the suction side which should be on the right side of the compressor......
Boiler feed pump's suction pressure be aprox. 15Kg/cm2 and discharge pressure be 180Kg/cm2. So the balancing line balance the pressure and protect the boiler feed pump. my quastion is that what is the working principal of balancing leak off