First, you need to know the mass of brass:
Brass, Specific Gravity 8.56 lb per Cubic Foot (from wikianswers)
second: you need to know the length and radius of the rod.
formula: divide the radius of the rod by two
square the answer you get (multiply it by itself)
multiply by pi
You have now calculate the area of the rod's end.
multiply the answer by the length of the rod and you get the volume of the rod
finally, multiply the answer by the specific gravity for brass.
The answer is the weight of the brass rod
NOTE: make sure you use the same units for length and mass throughout the formula. In the above example you will have to know the radius and length in feet to yield the weight in lbs. If you want to know the answer in a different unit (ounces for example) you will have to convert the specific gravity to correct units.
AREA*THICKNESS(length)*7.85 pi*r2*t*7.85 - in mm
How to calculate round column volume. +== No formula given so how can the "answer" be useful? The volume of a round column of radius r and height h is that of any cylinder: r^2.pi.h.
formula calculation of steel round bar > Area (square metres) of cross section * 7850 = kilograms per metre length. For other lengths, multiply answer by length in metres.
A round swimming pool is a right circular cylinder, so you can use the formula pi times the radius squared times the height to calculate the volume.
Density or weight is calculated by mass/volume
you use the formula: Pi x radius (half the diameter) squared.
diamater 1300 x Hight 1800. what is the volume in litres
Calculate the round column shuttering
First calculate cubic feet: 3.1417 x Radius² x Depth = cubic feetNext calculate gallons: Cubic ft x 7.47 = gallons
Assuming the cross-section is a circle, and the walls go straight down, just use the formula for a cylinder.
To Round To The Nearest Of Sumthing
It's not "necessary" because all the brass will be sized through your sizing die and all will be safe to use sans any damage or wear. However, you'll get much better accuracy separating the brass by manufacturer and case weight. The rule for accuracy is to have each round as close to exactly the same as the one shot before it as possible.