0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the transmission fluid reservoir for a 1981 Monte Carlo?
the tranny itself is the reservoir, check the level on the tranny dipstick to see that it is full.
What should the raidiator coolant level be?
The coolant level is set by the level in the coolant reservoir. There is a line for the level if the engine is cold and a line for if the engine is up to temperature. You should fill it to the corresponding line.
Do you add coolant to the reservoir or the radiator?
If there is a cap on the radiator you can check to see if the radiator is full , and if it isn't , " top up " the engine coolant . Otherwise , you check the engine coolant level at the engine coolant reservoir when the engine is cold and maintain the level at the cold mark
What is a sentence with word reservoir?
The reservoir is always either full or empty.
How do I check to see if my brake fluid is low on a Renault clio?
To check and see if your brake fluid level is low, locate the brake fluid reservoir. If the level of the fluid does not reach the 'full' line on the reservoir, add some.
How deep is the hoover reservoir in westerville Ohio?
85 feet - when the reservoir is full
How do you put in antifreeze in a 1992 Toyota Previa after flushing out the system?
Open the hood and the Coolant reservoir on the '92 Previa is next to oil reservoir on the left side. Unscrew radiator cap from the coolant reservoir, add the 50/50 mix of coolant fluid into the reservoir. (Recommend use Prestone extended life coolant) Fill the coolant into the reservoir, it take about 3 gallon, and be sure that the coolant is pass the full mark of the reservoir. Now, turn on the car, during the engine running (about 10 minutes) kept check the level of coolant be sure it still maintains pass the full mark level. Screw back the radiator cap to coolant reservoir. Run engine for another 30 minute. This will ensure that thermostat is open and and ensure the fluid is circular all around of the radiator and hoses. Waite engine cool down, then open the radiator cap and check the coolant fluid level. If the level is low then add more coolant. Do not fill the coolant pass the full Mark's point. If the coolant fluid is still the same as in full mark then it is good. Continue to check the coolant fluid for next couple day. Besure that it is at the full level mark.
How much coolant to fill a 1997 Saturn sw1?
The amount of coolant it will take to fill your vehicle is dependent upon how low the coolant level is. You can add coolant to your coolant reservoir. The reservoir will have an indicator of when the coolant system is full.
Why would Jaguar XJ6 windshield wiper indicator be on if reservoir is full?
Level sensor may be defective or disconnected. Possible wire could be damaged.
Why is 1996 Sunfire radiator warning light flashing randomly when radiator is full?
When the engine is cold, check the level of the coolant in the reservoir. Make sure it's up to the mark on the side. Make sure you get the reservoir cap on tight.
Check coolant level?
To check the coolant level of a vehicle first see look for the overflow reservoir. There should be a coolant dipstick with a level gauge on it. Remove it from the reservoir to see the coolant level.
The radiator symbol is showing but the reservoir is full what is the problem?
It could be one of several issues: 1. The sensor in the radiator overflow bottle is stuck, disconnected or damaged 2. The actual level of fluid in the radiator itself is low, perhaps caused by a blockage or interruption in the overflow tube that connects the radiator and the overflow bottle 3. The thermostat is stuck in the open or closed position, requiring a replacement of the thermostat First things to check: 1. While the vehicle engine is COLD, check that the level of fluid in the reservoir does not exceed the COLD level. 2. Run the vehicle for 20 to 30 minutes of normal driving, then check the reservoir level. The level of fluid in the reservoir should be raised to the HOT level. 3. Let the engine completely cool for several hours. Check the reservoir level again. It should have dropped back down to the COLD level. If the level in the reservoir does not change between the times the engine is cold and hot, you have a problem with your engine's cooling system. Wait several for the engine to completely cool, then open the radiator cap and verify that the radiator is full of fluid. Check the overflow tube that runs from the radiator neck to the reservoir bottle to ensure that it is free of obstructions.
