0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Difference between power and furnace transformer?
Power transformer is used step up or down the voltage for the electricity transmission while furnace transformer is used to melt the metals and ores in the electric furnace.
What is the problem of operating a on-load furnace transformer with center tap?
What is the problem of operating a on-load furnace transformer with center tap
What type of transformer is used in a resistance furnace?
A resistance furnace runs on electricity so it will be some type of electrical transformer.
Why does an oil furnace require a step-up transformer?
An oil furnace has a step up transformer to generate a spark to ignite the oil spray at the tip of the nozzle.
Why was power lost to a heat and air thermostat?
The power to the thermostat comes from the transformer in the furnace or air handler whichever you have. 1) the power to the furnace/AH is off, 2) the control fuse that protects the transformer is blown, 3) the transformer is defective, 4) the wire between the furnace and the thermostat got cut.
Replaced the thermostat and the furnace works but wont turn on?
Sounds like you might have a blown transformer, or a blown fuse on the transformer. Hope for the fuse. Its on the Furnace. Be sure your white wire is on the heat side of the thermostat, and the red wire is on the correct terminal also. The transformer can be checked with a voltmeter.
What size transformer is generally used on a heating only gas furnace?
usually 40 va
What is the use of reactor transformer in furnace?
Stabilise the arc and optimize the operation of the furnace.
Your furnace blows but will not fire up?
Gas furnace have several safeties installed for your protection. If for some reason one of these safeties are not opening or closing the furnace will not fire. Most likely the pressure switch, high limit or transformer may be faulty. If it is an older model check the thermocouple.
Where is a step up transformer used in the home?
An example would be if you had a oil furnace, the ignition system would be a step up transformer. The step up 120 volt to 15000 volt transformer is used to ignite the fuel that comes out of the nozzle under high pressure to make the fuel burn.
What can cause a humming noise in the attic when the furnace is on?
If the furnace itself is in the attic, the humming is likely caused by electrical components in the furnace--most likely, the blower motor, or else a transformer or relay coil. If the furnace is located elsewhere, the humming may be caused by a damper motor or possibly the air movement itself vibrating a damper or some sheet metal.The HVAC Veteran
Is 24 volt 20va transformer in furnace is this big enough to put on wifi thermosate?
ya it should work fine. and if not get a battery powered wifi thermostat
