I/O devices accept or release information at much slower rate than the microprocesor. Handshaking is the method that synchronize the I/O device with microprocessor.
Pins 1 and 20 in the 8086 microprocessor are (both) power and signal ground (GND).
They are the ways of transmitting parallel data to the microprocessor. In single handshake, a peripheral device first sends a "Strobe signal" to the microprocessor to indicate that it is ready to send data. The microprocessor , upon detecting the strobe signal, opens up its input port and receives the data. After receiving data, it sends an "Acknowledge signal" to the peripheral to indicate that transmission has been completed.A transmission session has been completed. In double handshake, first the peripheral device sends a strobe signal, the microprocessor, sends the acknowledge signal to indicate that it is ready to receive data. After which data is received.After sending data, the peripheral sends a strobe signal to indicate data transmission completion, due to which, the microprocessor drops its acknowledge signal and a session has been completed. The only difference in the two is that, in double handshake, the peripheral is informed about the microprocessor's readiness to receive data. This is doesn't happen in single handshake. So the name follows "double handshake", literally meaning "double confirmation".
The 8086 microprocessor has 40 pins.
It is mightily referring to Microprocessor 8086 . I think you saw "8086 microprocessor". The 8086 is nothing it indicates the number of microprocessor same as Digital or analog ic's . 8086 microprocessor has 20 Address buses and 8 data buses which has 1 Mb inbuilt memory for performing several type of airthmatical and logical operation.
queue of 8086 microprocessor is 6 bits
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
it is a 16 bit microprocessor & it has 40 pin .
8086 main application is to evaluate the arithmetic operations in any systems that uses 8086
Two ground pins are used in the 8086 microprocessor to increase the bus pull-down current capacity.
Which microprocessor accepts the program written for 8086 without any changes?
Its 16bit microprocessor,and-> the 8086 has a 16bit databus 20bit address bus-> the intel 8086,is designed to operate in two modes namely(1) minimum mode(2) maximum mode
ya possible