"Lapping" of valves is a method of smoothing the seating areas of the valve. There are specific angles that the valve seats into and lapping is a very precision way of making that fit as tight as possible.
Lapping is a grinding process. It is done to remove high spots and to create a good seal between two surfaces. A typical example would be lapping valves in an auto engine
The difference is "soft seated" or "metal seated". Soft seated valves are used in gas applications were any leakage is absolutely not tolerated. The materials used are Teflon or ceramic. Metal seated valves can have very tight shut-off, it all depends on the coating, pressure in the line, and the lapping of the surfaces.
Mechanism with side camshaft and Mechanism with overhead camshaft both valve actuating mechanisms are used to operate inlet or exhaust valves.
I'm not famiar with the Grundfos valves specifically, but non-return valves are usually fitted to the suction side of pumps to prevent the pump from losing it's prime when it is stopped (by draining back through the inlet).
engine block, piston, cylinder head, cylinder liner, camshaft, crankshaft, valves, crankcase/sump, inlet manifold, exhaust manifold, cylinder head cover
Inlet Guide Valves
Lapping is a grinding process. It is done to remove high spots and to create a good seal between two surfaces. A typical example would be lapping valves in an auto engine
There is 4 exhaust and 8 inlet valves
inlet and exaust valves are usually opened by a lobe on a crankshaft, either directly, or with a pushrod and rocker arm assembly.
it opens and lets the fuel and air mixture into the cylinder head INLET VALVES
it opens and lets the fuel and air mixture into the cylinder head INLET VALVES
The purpose of the inlet valves in a petrol driven automobile is to allow gas pass into the combustion chamber.
Cast iron with Crome 25%
same direction and forward.
Lobes on camshaft spaced correctly
Lapping the valves is the final step in assuring a tight seal between the valve and the valve seat.
The purpose of the inlet valves in a petrol driven automobile is to allow gas pass into the combustion chamber.