the voltage which is mainly applied to primary side of the transformer is called rated voltage.
Answer'Rated voltage' is the nominal voltage at which an electrical device has been designed to operate.
The ratings state the limits on voltage and current for operating the transformer at full load. The rated voltage times the rated current gives the rated VA of the transformer. Transormers are not usually rated directly for power because this depends on the power factor of the load applied.
Rated voltage is the voltage at primary side. Rated current can be found from the equation, Rated Current= Output KVA / Output rated voltage
Simply, the voltage which is withstand by the test object as an impulse is called as rated impulse voltage.
It depends where you bought it. In North America, its rated voltage will be 120 V whereas, in Europe, its rated voltage will be 230 V.
Regulation =(Obtained voltage per phase - rated voltage per phase)/rated voltage per phase *100
It is the rated test voltage that will not cause insulation breakdown.
no
The MAXIMUM rated voltage is the voltage at which the electricity would arc across the insulators The usage voltage is lower than the rated voltage (usually somewhere around 80% The lightning arrestor voltage is in between. It will not pass current at the usage voltage, but will pass current when the voltage exceeds the arrestor threshhold
A low voltage fuse should be rated for 30 amps.
Sure, as long as it's rated for that voltage.
To operate at its rated power, a lamp must be subject to its rated voltage (the supply voltage). As each branch of a parallel circuit is subject to the same voltage (the supply voltage), each lamp will operate at its rated power.
The lamp needs to be rated for the voltage applied to it. The fixture in which the lamp is installed also needs to be rated for the voltage. So, it is not a matter of changing the lamp, it is a matter of having the fixture and lamp that are properly rated for the voltage that you are applying to it.