Fifty millionths of a farad, abbreviated as 50 uF. Farad is the unit of capacitance. 50 microamps DC flowing for 1 second will charge a 50 uF capacitor to 1 volt.
1000 microamps = 1 milliamp
Start by using Ohm's law. 10 volts and 200 microamps requires 50,000 ohms. From that, subtract the impedance of the meter. Place the final resistor in series with the meter. Add a resistor in series of such a size that when there is 10v it will allow 200 u amps to flow.
Dc chopper is a static device which converts constant dc source to variable dc.
It depends on the particular diode. They range from around a hundred volts to several thousand volts, depending on what you want to spend.
Fifty millionths of a farad, abbreviated as 50 uF. Farad is the unit of capacitance. 50 microamps DC flowing for 1 second will charge a 50 uF capacitor to 1 volt.
Multiply by 1,000,000
1000 microamps = 1 milliamp
None. Amps and Ohms measure different things.
Start by using Ohm's law. 10 volts and 200 microamps requires 50,000 ohms. From that, subtract the impedance of the meter. Place the final resistor in series with the meter. Add a resistor in series of such a size that when there is 10v it will allow 200 u amps to flow.
6 volts divided by 100 megohms is 0.06 microamps.
Current and it is measured in amps, milliamps or perhaps microamps.
Electrical current is measured in amperes, or amps for short. Smaller currents might be measured in milliamps or microamps.
You are confusing terms. Current is measured in amps or some fraction thereof. If you have a 24 volt battery (All batteries are DC) you need to connect a load to the battery and then measure the current that flows in the circuit. The current is measured in amps, milliamps or perhaps microamps for a very high resistance load.
Quote: Some dental amalgams contain up to five dissimilar metals. Galvanic action between the metals different electrical potentials creates a electric cell in the tooth, which can generate currents of up to 10 microamps, a huge spike over normal body nerve currents of 3 microamps.
The answer depends on the units which were used for 0.026. For example, 0.026 milliamps would be 0.026 milliamps while 0.026 microamps would be 0.000026 milliamps.
There are 1000 microamps in one milliamp. Each derived SI unit in each direction is three decimal places as in all engineering form.