A Regulator Clock noted on a glass door is for the viewer to be allowed to "regulate" time........ it is a classical time portal to enable advanced civilizations to "travel" without the need for mechanical devices. It is a dangerous way to travel for the desination; past or future; may not be there .... beware of the butterfly effect. For more information on this subject please contact Josh by placing your question on a piece of paper , burn it and the smoke signal will be answered either in the past or future.
glass
Less then Peyton Manning.
Here's the set of steps: 1. Remove door trim casing. 2. Carefully release water shedder from door. 3. Lower glass and remove 2 bolts securing door glass to regulator. PERHAPS THESE BOLTS ARE LOOSE OR MISSING? 4. Raise glass and secure with a suitable wedge. 5. Disconnect multiplug from glass lift motor. 6. Front door: Remove 6 bolts securing glass regulator assembly to door. 7. Rear door: Remove 4 bolts securing glass regulator assembly to door. 8. Manoeuvre regulator through access hole at bottom of the door. 9. Remove 3 Torx screws securing glass lift motor to regulator and remove motor. Refit 1. Clean mating faces of regulator and motor. 2. Fit glass lift motor to regulator and tighten 3 Torx screws to 5 Nm (3.7 lbf.ft). 3. Position regulator in door. Fit bolts securing regulator to door and tighten to 6 Nm (4.4lbf.ft). 4. Connect multiplug to glass lift motor. 5. Remove wedge holding glass and position glass to regulator. 6. Secure glass to regulator with bolts and tighten to 6 Nm (4.4 lbf.ft). 7. Fit water shedder to door. 8. Fit door trim casing."
a small dish
Are you talking about the glass or window regulator?
undo the glass from the regulator and pull it up out of the door and get new gass and drop it down inside the door into the window channels and rehook the glass to the regulator.
pull inside door panel off and look inside the door and unhook the glass from the regulator and pull the glass up out of the door, to reinstall drop new glass into door channels and hook to regulator by factory hook-ups.
Another name for sand clock is hour glass
They are used to attach the glass to the window regulator, the mechanism that moves the glass up and down.
Lower the window glass. Remove door panels and any covering/insulation on inside.look in the interior of the door. The windows will be attached to the regulator. Remove the inner glass stablizers. Hold the glass firmly, remove the two mounting bolts holding the glass to the regulator.
Only if you change out the entire regulator. The power regulator unit is pitched a little different due to the power motor components.
Unless the glass is broken then there is no reason to remove it. If you have a problem it is possibly the motor or regulator.