0
area id
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is routing in networks?
This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.
What is static routing in networking?
This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.
What is the router prompt when in USER EXEC mode?
Router> Which means the user has entered the EXEC mode of the router.
What would happen when you manually added an entry you entered the correct i p address but the wrong Ethernet address for that remote interface?
Once the router/adaptor received the destination IP address (even if we entered in the incorrect MAC address) the router/adapter would remove the IP address from the Ethernet frame and using ARP, would get the correct MAC address of the destination
What do you put for the ssid on internet on psp?
The SSID is the 'name' of your wireless router. You should have given it a specific name when setting the router up - your PSP should normally be able to detect it when scanning, but if you've set it to invisible, you need to enter the SSID manually.
When are static routes used on a network?
to config a router manually
Which command is used to manually encrypt passwords on a Cisco router?
manual encryption
Can we update the D-link router firmware manually?
Yes, it is possible by downloading the firmware’s recent version through dlink-router-local.net support website.
In a Cisco router when do changes made to the running-configuration take effect?
as the commands are entered
try setting the rout?
try setting the router back to factory default, manually put in a wep security key (instead of letting it generate one), set the router to 54Mbps.
Does belkin n wireless router work with the sony ps2 network adapter?
Yes, but you may have to manually change the setting in the router to accept 802.11g connections. The Belkin default is the newer 802.11n standard.
What method should be used when applying IPv4 addresses to router interfaces on a network?
When applying IPv4 addresses to router interfaces on a network, you would manually configure predictable addresses. For example, the lowest or highest address of the local subnet, on each particular router interface.
